RADWAG MA X2.IC.A Series - Page 112

- 112 -
x → g, mg, ct, lb, oz, ozt, dwt, tlh, tls, tlt, tlc, mom, gr, ti, N, baht, tola, u1, u2
Example:
Command:
UI <CR><LF>
- return available units
Response:
UI_”g, mg, ct”_OK<CR><LF>
- response: available units
Set current unit(weighing mode exclusively)
Command overview:
Command sets current unit for a particular device.
Format:
US_x <CR><LF>
Response options:
US_ x_OK <CR><LF>
- command carried out, returns accessible units
US_E <CR><LF>
- error in-course of command execution, no parameter or
incorrect format
US_I <CR><LF>
- command understood but not accessible at this moment
x - parameter, units symbols: g, mg, ct, lb, oz, ozt, dwt, tlh, tls, tlt, tlc, mom, gr, ti, N, baht,
tola, msg, u1, u2, next
CAUTION:
If x=next the command swaps to another available unit on the list (it simulates button
pressing, or taping unit field in mass window).
Example:
Command:
US_mg<CR><LF>
- set „mg” unit
Response:
US_mg_OK<CR><LF>
- „mg” set as a current unit
Give current unit
Command overview:
Command returns current unit.
Format: UG <CR><LF>
Response options:
UG_x_OK<CR><LF>
- command carried out, returns accessible units
UG_I <CR><LF>
- command understood but not accessible at this moment
x - parameter, units symbols:
Example:
Command:
UG<CR><LF>
- return current unit
Response:
UG_ct_OK<CR><LF>
- currently set unit is „ct”
Activate sound signal
Command overview:
Command activates BEEP sound signal for a specified amount of time.
Format: BP_TIME<CR><LF>
Response options:
BP_OK <CR><LF>
-
command carried out, BEEP activated
BP_E” <CR><LF>
- no parameter or incorrect format
BP_I <CR><LF>
- command understood but not accessible at this moment
TIME - parameter, decimal value specifying how long shall the sound last, parameter given
in [ms]. Recommended range <50÷ 5000>.