RADWAG MA X2.IC.A Series - Page 114

- 114 -
A_OK <CR><LF>
- command carried out
A_E <CR><LF>
- error in-course of command execution, no parameter or incorrect
format
A_I <CR><LF>
- command understood but not accessible at this moment
N - parameter, decimal value determining autozero settings:
n → 0 – autozero off
1 – autozero on
Caution: Command changes settings for a current working mode.
Example:
Command:
A_1<CR><LF>
- turn autozero function on
Response:
A_OK<CR><LF>
- autozero function is on
AUTOZERO function operates until it is turned off by A 0 command.
Set ambient conditions state
Format: EV_n <CR><LF>
Response options:
EV_OK <CR><LF>
- command carried out
EV_E <CR><LF>
- error in-course of command execution, no parameter or incorrect
format
EV_I <CR><LF>
- command understood but not accessible at this moment
n - parameter, decimal value determining ambient conditions state
n → 0 – unstable ambient conditions
1 – stable ambient conditions
Caution:
Command changes settings for a current working mode.
Example:
Command:
EV_1<CR><LF>
- set value ‘stable’ for ambient conditions option
Response:
EV_OK<CR><LF>
- set value ‘stable’ for ambient conditions option
<AMBIENT CONDITIONS> parameter is set to value <STABLE> until command EV 0 swaps
it to value <UNSTABLE>.
Give set ambient conditions state
Command overview:
Command gives information about state of currently set ambient conditions.
Format: EVG <CR><LF>
Response options:
EVG_x_OK<CR><LF>
- command carried out, response: set ambient conditions state
EVG_I <CR><LF>
- command understood but not accessible at this moment
x - parameter, ambient conditions symbols
Example:
Command:
EVG<CR><LF>
- give current ambient conditions state
Response:
EVG_0_OK<CR><LF>
- current ambient conditions state: unstable
Set filter
Format: FIS_n <CR><LF>
Response options:
FIS_OK <CR><LF>
- command carried out
FIS_E <CR><LF>
- error in-course of command execution, no parameter or incorrect