R&S NRP2 - Page 126

Instrument Functions
R&S
®
NRP2
108User Manual 1173.9157.02 ─ 03
"1"
SWR, RCoeff
"dB"
RLoss
SCPI command:
UNIT<[1]..8>:POWer on page 331
UNIT<[1]..8>:POWer:RATio on page 332
4.4.3.5 Displaying additional information
In display mode "Dig", up to three further values with helpful information can be displayed
in the results window, in addition to the current measurement result.
Fig. 4-41: Function & Unit dialog box, Auxiliaries
Example:
In the example, the auxiliary function is set to "Extremes", i.e. the maximum, the minimum
and the max-min value are indicated.
See also chapter 3.6.2, "Special symbols", on page 58 for information concerning the
displayed symbols and values.
The R&S NRP2 continuously saves the data that is required for the display of extreme
and statistic values. The data memory can be erased any time with "Aux Val Reset" in
the "Measurement" menu, see also chapter 4.4.6, "Resetting auxiliary information",
on page 111.
Aux.
Selects the additional information to be displayed
"None"
Displays no additional information.
Configuring measurements