R&S NRP2 - Page 296

Remote Control - Commands
R&S
®
NRP2
278User Manual 1173.9157.02 ─ 03
[SENSe<[1]..4>]:SGAMma:CORRection:STATe <state>
Activates/deactivates the measured-value correction of the reflection coefficient effect of
the source gamma.
Parameters:
<state> ON | OFF
*RST: depending on sensor
Usage: Setting only
[
SENSe<[1]..4>]:STATistics:AVERage? <power_value>
Returns the average power value calculated during a statistics measurement (CCDF/
PDF).
Unit: DBM | W | DBUV
Parameters:
<power_value> float_value
Default unit: DBM
Usage: Query only
[SENSe<[1]..4>]:STATistics[:EXCLude]:MID:OFFSet[:TIME] <time_interval>
Together with SENS:STAT:MID:TIME, allows a time interval within the time window to
be blanked out; in this interval, the data for the statistics is collected.
SENS:STAT:MID:OFFS determines the distance from the start of the measurement to
the start of the interval to be blanked out (see also [SENSe<[1]..4>][:POWer]:
TGATe<[1]..4>[:EXCLude]:MID:OFFSet[:TIME]  on page 272).
Parameters:
<time_interval> float_value
Range: depending on sensor
*RST: depending on sensor
Default unit: S
[SENSe<[1]..4>]:STATistics[:EXCLude]:MID:TIME <time_interval>
Together with SENS:STAT:MID:OFFS, allows a time interval within the time window to
be blanked out; in this interval, the data for the statistics is collected.
SENS:STAT:MID:TIME determines the length of the interval to be blanked out (see also
[SENSe<[1]..4>][:POWer]:TGATe<[1]..4>[:EXCLude]:MID:TIME
on page 273).
SENSe (Sensor Commands)