R&S NRP2 - Page 338

Remote Control - Commands
R&S
®
NRP2
320User Manual 1173.9157.02 ─ 03
SYSTem:ERRor:EXTended[:STATe] <state>
SYST:ERR:EXT ON activates extended error messages (SYST:ERR?). The location of
errors in the parsed command strings is also shown.
Parameters:
<state> ON | OFF
*RST: OFF
SYSTem:KEY <key_stroke>
This command is used for testing purposes only and simulates a single stroke of an
R&S NRP2 frontpanel key.
The key stroke to be simulated is described either in plain text (<character_value>)
or by a key code (<NR1>) , see following table.
Table 6-34: Valid parameter values for the SYSTem:KEY command.
Simulated front-panel key <character_value> <NR1>
"Softkey toggle 1 left"
SK1L 1
"Softkey toggle 1 right"
SK1R 2
"Softkey toggle 2 left"
SK2L 3
"Softkey toggle 2 right"
SK2R 4
"Softkey toggle 3 left"
SK3L 5
"Softkey toggle 3 right"
SK3R 6
"Softkey toggle 4 left"
SK4L 7
"Softkey toggle 4 right"
SK4R 8
"Softkey toggle 5 left"
SK5L 9
"Softkey toggle 5 right"
SK5R 10
"Softkey toggle 6 left"
SK6L 11
"Softkey toggle 6 right"
SK6R 12
(PRE)SET
PRESet 13
ZERO
ZERO 14
FREQ
FREQ 15
MODE
Ⓘ Power
POWer 17
DEL / 1 TRIG
DELete 18
↵MENU
ENTer 19
ESC / LOCAL
ESCape 20
⇧
UP 21
SYSTem