94
5.8.7 Viewing the [Editor] Window
The [Editor] window corresponding to the selected trace record can be displayed in the following two ways:
• Select a trace record and choose [View Source] from the popup menu.
• Double-click a trace record
The [Editor] or [Disassembly] window opens and the selected line is marked with a cursor.
5.8.8 Trimming the Source
Choose [Trim Source] from the popup menu to remove the white space from the left side of the source.
When the white space is removed, a check mark is shown to the left of the [Trim Source] menu. To restore the
white space, choose [Trim Source] while the check mark is shown.
5.8.9 Acquiring a Snapshot of the Trace Information
A snapshot can be acquired when you need to check the trace information during execution of the user program.
This is useful for checking time stamping or probe input signals. To acquire a snapshot of trace information,
select [Snapshot] from the popup menu. Trace acquisition is temporarily stopped to display a record of the latest
trace information, and then restarted. A snapshot of trace information is only acquired during execution of the
user program.
5.8.10 Temporarily Stopping Trace Acquisition
To temporarily stop trace acquisition during execution of the user program, select [Halt] from the popup menu.
This stops trace acquisition and updates the trace display. Use this method to check the trace information without
stopping execution of the user program.
5.8.11 Restarting Trace Acquisition
To restart trace acquisition being stopped during execution of the user program, select [Restart] from the popup
menu.
To Next Page
Loading...
Need help?
General
