Renesas H8 Series User Manual

241
Appendix D Diagnostic Test Procedure
This section describes the diagnostic test procedure using the E6000 test program.
D.1 System Set-Up for Test Program Execution
To execute the test program, use the following hardware; do not connect the user system interface cable, user
system, or expansion I/O board.
• E6000 emulator (HS3664EPI61H or HS3664EPI62H)
• Host computer
• The E6000 PC interface board (select either from the followings according to the PC interface
specifications):
PCI bus interface board (HS6000EIC01H or HS6000EIC02H)
PCMCIA interface card (HS6000EIP01H)
LAN adapter (HS6000ELN01H)
USB adapter (HS6000EIU01H or HS6000EIU02H)
1. Install the E6000 PC interface board in the host computer and connect the supplied PC interface cable to the
board.
2. Connect the PC interface cable to the emulator.
3. Connect the supplied AC adapter to the emulator.
4. Initiate the host computer to make it enter DOS prompt command input wait state.
5. Turn on the emulator power switch.

Renesas H8 Series Specifications

General

Brand	Renesas
Model	H8 Series
Category	Computer Hardware
Language	English