195
8.1.12 Searching for a Trace Record
While using the emulator, the [Trace Find] dialog box has the following pages:
Table 8.12 [Trace Find] Dialog Box Pages
Page Description
[General] Sets the range for searching.
[Address] Sets an address condition.
[Data] Sets a data condition.
[R/W] Selects the type of access cycles.
[Area] Selects the area being accessed (not available when a time stamp is
acquired).
[Status] Selects the status of a bus (not available when a time stamp is acquired).
[Probes] Selects the status of four probe signals (not available when a time stamp
is acquired).
[Timestamp] Specify the time stamp value for bus cycles (only available when a time
stamp is acquired).
8.1.13 Trace Filtering Function
While using the emulator, the [Trace Filter] dialog box has the following pages:
Table 8.13 [Trace Filter] Dialog Box Pages
Page Description
[General] Selects the range for filtering.
[Address] Sets address conditions.
[Data] Sets data conditions.
[R/W] Selects the type of access cycles.
[Area] Selects the area being accessed (not available when a time stamp is not
acquired).
[Status] Sets the status of a bus (not available when a time stamp is not
acquired).
[Probes] Selects the states of four probe signals (not available when a time stamp
is not acquired).
[Timestamp] Specifies the time stamp value for bus cycles (only available when a time
stamp is acquired).
To Next Page
Loading...
Need help?
General
