116
(4) Access Count Of Specified Range Measurement
Figure 5.64 Access Count Of Specified Range Measurement Settings
[Range Name]: The name of the range to be measured
[Range]: The range for the Access Count Of Specified Range Measurement
[Start Address]: Start address
[End Address]: End address
[Access Area Range]: The access range for the Access Count Of Specified Range Measurement
[Start Address]: Start address
[End Address]: End address
[Access Type]: The bus cycle on the access range to be measured
Measures the number of times the range specified as the access range is accessed from the range specified by the
start and end addresses. The execution count in the range is measured with Time Of Specified Range
Measurement mode.
Note: Available bus cycle conditions vary according to the emulator in use. For details, refer to section 5.7.4,
Signals to Indicate Bus States and Areas.
To Next Page
Loading...
