Renesas H8 Series User Manual

243
The following messages are displayed during test. This test consists of steps 1 to 20. This example assumes that
HS3664EPI62H is in use. Time required for this test depends on performance of the host computer and PC
interface in use (approximately 2 to 10 minutes).
Message Description
E6000 H8/3664 Emulator Tests Vx.x
Copyright (c) 2001, 2003 Renesas Technology Corp.
Test program start
message. Vx.x shows the
version number.
Loading driver .......................OK
Initializing driver ..................OK
Searching for interface card .........OK
Shows that the PC
interface board is
correctly installed in
the host computer.
Checking emulator is connected .......OK Shows that the E6000 is
correctly connected to
the host computer.
Emulator Board Information:
Main Board ID: H'05 Shows the ID number of
the lower board of the
E6000 (always 5).
Emulation Board ID: H'17 Shows the ID number of
the upper board of the
E6000 (always 17).
SUB board ID: H'f Shows the ID number of
the E6000 (expansion I/O
board) as f.
Option memory board: None Shows whether the SIMM
memory board is
installed.
01) Test Register:
A) IDR0 Register ..................OK
B) PAGE Register ..................OK
C) TRACE G/A Register..............OK
D) PERFM G/A Register..............OK
E) CES G/A Register................OK
F) IDR1 Register...................OK
G) IDR2 Register...................OK
Shows the check results
for the registers in the
E6000 (normal
completion).
02) Test DPRAM :
A) Decode Test ....................OK
B) Marching Test ..................OK
Shows the results of
decoding test and
marching test for the
dual-port RAM in the
E6000 (normal
completion).

Renesas H8 Series Specifications

General

Brand	Renesas
Model	H8 Series
Category	Computer Hardware
Language	English