2. Change the [Image Quality/Speed] setting as required.
Select [Quality], [Standard Image Quality], or [Speed], according to the specified quality under
the image transfer settings. The default is [Speed]. To give priority to speed over quality, select
[Speed]. The print quality, however, may be degraded.
3. Change auto disconnection settings as needed.
To enable auto disconnection while the machine is connected to a computer, open the pull-down
menu, and then select the length of time the auto disconnect message is displayed. When the
setting is enabled, the auto disconnect message is displayed at specified intervals. If one minute
elapses without clicking [Continue] in the message, the connection is lost automatically.
4. Click [Connect].
The screen of the computer appears on the machine screen.
5. When you operate the computer from the machine, touch , the Operate Computer
icon.
A pen nib and pen bottom can be used to perform the following:
Using IWB Remote Desktop Software
135
To Next Page
Loading...