shooting
User primary message Explanation
SMTP server not setup.
Contact system
administrator
The devices primary and secondary SMTP fields are blank.
This needs to be configured by the system administrator.
No Analog Phone Line
An analog line is not detected as being plugged into the
modem. If the device is in Analog mode, this has a source of
Fax. If the device is in Fax Server mode, and the 'Enable
analog receive' Fax Server setting is set to 'On', this has a
source of Fax Receive. If the device is in Fax Server mode
and the 'Enable analog receive' Fax Server setting is set to
'Off', then this IR is not generated.
Memory Full, cannot print
faxes
Attempted print is automatically canceled. The Fax code will
recognize that the print job has been canceled and will not
delete pages in the fax job that have not printed. Fax will not
attempt to reprint the fax that generated the out of memory
error until a POR is performed.
Memory Full, cannot send
faxes
After a start, there is no memory to do the fax job. Attempted
fax is cancelled.
Fax server ‘To Format’ not
set up
Device is in Fax Server mode. The To format for the Fax
Server setup is null. Analog receive still possible.
Fax Station number not
set up.
Held jobs may not be
restored
This message is only posted once after the firmware has
tried to restore all of the jobs on disk, regardless of the
number of held jobs that were not restored. There are three
versions of this IR, depending upon cause. IRHeldA occurs
when any other condition occurs which stops the machine
from restoring jobs from disk. These might include disk
failure, user abort, etc.
To Next Page
Loading...
