shooting
User primary message Explanation
34 Short Paper
Press "Select" ( ) to clear the message and continue
printing. The machine does not automatically reprint the
page that prompted the message.
Check tray length and width guides to ensure paper is
properly fitted in the tray.
Make sure the print job is requesting the correct size of
paper.
Adjust the Paper Size setting for the size paper you are
using. If MP Feeder Size is set to Universal, make sure
the paper is large enough for the formatted data.
Cancel the current job.
35 RES Save Off Deficient
Memory
This message displays when the machine lacks sufficient
memory to enable Resource Save. This message usually
indicates the user has allocated too much memory for one or
more of the printer link buffers; however, modification of
other printer settings which affect the amount of available
memory may also create this condition. If restoration of
Resource Save is required after this message is received,
the customer should install additional memory or set each
link buffer to Auto. Once all link buffers are returned to Auto,
you should exit the menu to activate the link buffer changes.
Once the machine returns to the Ready state, you can
enable Resource Save and go back and modify the link
buffers again. Note the reduction of available memory to the
link buffers when Resource Save has been enabled, and
compare it to the memory available when Resource Save is
disabled.
press Select (
) to disable Resource Save and
continue printing. To enable Resource Save after you
get this message:
-Make sure the link buffers are set to Auto, then exit the
menus to activate the link buffer changes.
-When Ready is displayed, enable Resource Save.
Install additional memory.
To Next Page
Loading...
