shooting
Error Description Action
200.06
Imaged page not expected page
(bouncy passthru sensor)
Remove the toner cartridge/PC kit.
At the front, remove the upper front
guide, and inspect the flag on the
manual input sensor. If the flag is
loose, then replace it. See “Media
Manual Input Sensor” in
“Replacement and Adjustment”.
200.08
Media reached the input sensor before
the EP was ready
Inspect the tray for prestaging.
Verify the proper media and inspect
the tray wear strips. Replace the
wear strips if necessary.
200.09 Transfer servo never started
Inspect the LVPS/HVPS. See
“Engine Board Service Check” in
“Troubleshooting”.
200.12
Media detected at manual feeder
sensor when not expected. Possible
causes include user insert of media
when motor is running or pre-staged
media in the tray.
Carefully remove the tray and notice
if the leading edge of the media is
pointed upward and out of the tray. If
so, then inspect the tray wear strips
and replace if necessary.
Inspect the input sensor flag and
replace it if it does not rotate freely
or is too loose.
200.13
The input sensor is covered when the
media is not expected (media in
machine during warm-up)
Remove the toner cartridge/PC kit
and inspect the input sensor flag.
Replace the flag if necessary.
200.14
Trailing edge cleared manual feed, but
did not successfully debounce the
sensor. Potential causes are a small
gap or a bouncy manual feed sensor.
Remove the toner cartridge/PC kit.
At the front, remove the upper front
guide, and inspect the flag on the
manual input sensor. If the flag is
loose, then replace it. See “Media
Manual Input Sensor” in
“Replacement and Adjustment”.
To Next Page
Loading...
