Ricoh M126 - Page 229

M126/M127/M128 6-24 SM
Error Description Action
200.15
UNRECOVERABLE NO GAP JAM.
Engine detected no gap at the manual
feeder sensor, attempted to open the
gap by stopping the feed rolls, but no
trailing edge was ever seen at the input
sensor.
Remove the toner cartridge/PC kit.
At the front, remove the upper front
guide, and inspect the flag on the
manual input sensor. If the flag is
loose, then replace it. See “Media
Manual Input Sensor” in
“Replacement and Adjustment".
Verify that the media is approved.
Inspect the wear strips in the input
tray, and replace if necessary.
200.16 Transport motor error detected
Inspect the main motor. See “Main
Motor Service Check” in
“Troubleshooting".
200.17
Took too long to ramp up transport
motor
200.18
Manual feeder sensor never became
uncovered from the sheet ahead.
Remove the toner cartridge/PC kit.
At the front, remove the upper front
guide, and inspect the flag on the
manual input sensor. If the flag is
loose, then replace it (
p.4-44
"Media Manual Input Sensor").
200.19
The media never reached the input
sensor, but was detected at manual
feeder sensor.
Remove the toner cartridge/PC kit,
and inspect for debris in the paper
path. Check the bottom of the PC kit
for any obstructions. Remove the
upper front guide, and inspect the
pinch rollers.
200.20
The media is too long over the manual
feeder sensor. Possible causes include
multi-sheet feed, media size (length)
problem, pre-staged media in the tray.
Verify that the media is approved.
Inspect the wear strips in the tray,
and replace if they are worn.