shooting
Error Description Action
200.22
Failed small gap or no gap jam
recovery. Engine detected small gap or
no gap at the manual feeder sensor,
opened the gap by stopping the feed
rolls, but never saw the leading edge of
the second page at the input sensor.
200.23
Laser Servo never started due to
potential conflict with the transfer
servo. Possible causes: slow or
missing transport motor positional
feedback, or the media is transferred
too quickly to the input sensor.
Verify that the media is approved.
Inspect the wear strips in the tray,
and replace if they are worn.
Check the main motor (
p.6-60
"Main Motor Service Check").
200.24
The measured gap at the input sensor
is too small to meet the video delivery
requirements. (There is not enough
time since prior image finished to start
new image)
Verify that the media is approved.
Inspect the wear strips in the tray,
and replace if they are worn.
200.26
The trailing edge never cleared the
input sensor when feeding out the
media that was detected during
warm-up.
200.27
Printhead Driver: Mirror motor fell out
of lock condition after the media at the
input sensor–more time elapsed since
the printhead than the expected stable
lock time, but less than the printhead
jitter-stable specification.
Check the printhead (
p.6-84
"Printhead Service Check").
Mirror motor fell out of lock condition
after media at the input sensor–more
time elapsed since the printhead than
expected stable lock time, but less than
the printhead jitter-stable specification.
To Next Page
Loading...
