shooting
Error Description Action
200.35
Failed to create hsync during auto
alignment
Check the printhead (
p.6-84
"Printhead Service Check").
200.36 Lost hsyncs during auto alignment
200.37
Timeout on data collection during auto
alignment
200.38
Interpage servo gap is smaller than
expected for printhead offset target
evaluation
200.42
Rogue sheet is at the manual feed
sensor while flushing the paper path
prior to declaring MPF source empty.
Retry alignment.
200.43
The media is at the input sensor before
interruption occurs. Possible causes
include bouncy sensor or an
exceptionally small gap, perhaps due
to the media being pre-staged in the
source tray.
Remove the media, realign the
stock, and re-insert. Do not let the
top sheets to go beyond the wear
strips.
201.00
Paper jam between input and exit
sensor
Remove the toner cartridge/PC kit
and check for obstructions between
the input sensor and the fuser. if the
media continues to stop at the
entrance or in the fuser, then
replace the fuser (
p.4-23 "Fuser
Removal").
201.01
Transport motor identification failed to
identify either motor after two tries.
Check the main motor (
p.6-60
"Main Motor Service Check").
201.02
Exit sensor never made by leading
edge of page. Also known as internal
jam.
Remove the PC kit and paper or
debris at the input sensor.
To Next Page
Loading...
