M126/M127/M128 6-28 SM
Error Description Action
201.03
Video never started on the page at the
input sensor within two inches after
hitting the input sensor
Check the printhead (
p.6-84
"Printhead Service Check").
201.05
Restart attempted after an internal jam
without the cover open/close event. It
is likely that the jam was never cleared.
Check the paper path and remove
any media in the path.
201.25
Exit sensor never made by leading
edge of media when feeding out the
media that was detected during
warm-up.
Remove the toner cartridge/PC kit
and check for obstructions between
the input sensor and the fuser. if the
media continues to stop at the
entrance or in the fuser, then
replace the fuser (
p.4-23 "Fuser
Removal").
201.26
Page at fuser nip before fuser started
ramping toward desired temperature.
Indicates code may be receiving more
interrupts than intended
201.27
Page at fuser nip before fuser reached
acceptable operating temperature.
Page arrived at fuser earlier than
expected, so it was probably staged
prematurely.
202.00 Paper jam around exit sensor.
Open the rear cover and look for
obstructions in the path way. If there
are none, then inspect for damage
at the fuser, rear door, exit guide,
and top cover. Often, the leading
edge of the media will indicate the
vicinity of damage. If damage is
found, then replace the damaged
part.
Print a page with the rear
door open to isolate the
fuser from the other parts.
To Next Page
Loading...
