shooting
Error Description Action
202.01
Exit sensor never broke on the trailing
edge of the sheet at the exit sensor.
Open the rear door, and inspect the
flag on the exit sensor. The flag is
located behind the fuser exit rollers,
about mid machine. If the flag does
not rotate freely or has no spring
action, then replace the fuser
(
p.4-23 "Fuser Removal").
202.02
Exit sensor never broke from sheet
ahead of page heading toward the exit
sensor.
202.06 Exit sensor bounced
202.13
Exit sensor covered, media not
expected (media not in machine during
warm-up)
202.25
Exit sensor never broke from the sheet
ahead of the page heading toward the
exit sensor when feeding out the media
detected during warm-up.
202.26
Trailing edge never cleared exit sensor
when feeding out media that was
detected during warm-up.
Open the rear door, and inspect the
flag on the exit sensor. The flag is
located behind the fuser exit rollers,
about mid machine. If the flag does
not rotate freely or has no spring
action, then replace the fuser
(
p.4-23 "Fuser Removal").
202.32
Long media or shingled multi feed
stopped before sending to duplex.
Check the paper setting and correct
if needed. While feeding along the
media, and immediately after it
enters the output bin, open the rear
door and obscure the trailing edge
and the sensor flag. If there is
slippage in the exit guide, then
replace the exit guide (
p.4-64
"Rear Exit Guide Assembly with
Sensor and Reversing Solenoid
Removal").
To Next Page
Loading...
