Ricoh M126 - Page 238

Messages and Error Codes
SM 6-33 M126/M127/M128
Trouble-
shooting
Error Description Action
290.02
Scanner ADF Feed Jam. The scanner
ADF has failed to feed a page to the
ADF interval sensor.
Remove the sheet of paper rom the
ADF. Retry the job. If the error
recurs, go to “ADF Paper Jam
Service Check” in
“Troubleshooting".
290.10
Scanner Static Jam - 1st scanner
sensor. Scanner ADF detects paper at
the first scanner sensor while the ADF
is in an idle state.
Remove all paper from the ADF.
Retry the job. If the error recurs, go
to “ADF Paper Jam Service Check”
in “Troubleshooting".
291.00
Scanner Static Jam - 2nd scanner
sensor. Scanner ADF detects paper at
the second scanner sensor while the
ADF is in an idle state.
292
Scanner jam, remove all originals from
the scanner. This message appears if
the ADF cover is open while paper is
fed through the ADF.
Remove the paper from the ADF,
and close the ADF cover. If the error
recurs, go to “ADF Cover Open
Service Check” in
“Troubleshooting".
293.02
Flatbed cover open. The machine
senses that the flatbed cover is open.
Close the flatbed cover (
p.6-92
"ADF Cover Open Service Check").
294.04
Scanner jam, remove all originals from
the scanner. Jam at the ADF exit
sensor.
294.06Remove all paper from the
ADF. If the error recurs, go to “ADF
Paper Jam Service Check” in
“Troubleshooting".
294.05
Scanner jam, remove all originals from
the scanner. A jam is detected at the
ADF exit sensor.
294.06
ADF Backfeed Jam. A jam is detected
at the ADF exit sensor.
295.01 Scanner Disable Page at CCD
ADF page gap is too small. Not
enough to re initialize the image
processing unit.
Remove paper from the ADF.