10. Reassemble the machine and route the ground wire [A] through the cutout in the upper left cover.
11. Connect the USB cable [B] to USB-A.
12. Install the optional booklet finisher to the left side of the machine.
13. Peel off the backing paper from one side of the hook and loop fastener, and then stick it to the
bottom of the USB2.0/SD slot [A].
14. Remove the other backing paper from the hook and loop fastener, and then attach the USB 2.0/
SD slot [B] to the middle position on the back of the optional booklet finisher [C].
15. Plug in and turn on the main power switch.
16.
Change the setting of Printer SP1-013-002 from "0" to "1".
17. Change the setting of Printer SP1-110-002 from "0" to "1".
18. Exit the SP mode, and then turn off the main power switch.
19. Check the operation of the USB2.0/SD Slot.
USB2.0/SD Slot Type H (D594)
163
To Next Page
Loading...
