5. Install the SD card [A] into the SD card slot 2 (for service use).
6. Turn on the main power switch.
7. Enter the SP mode.
8. Do SP5-846-051 (Backup All Addr Book).
9. Exit the SP mode, and then turn off the main power switch.
10. Remove the SD card from the SD card slot 2.
11. Install the controller cover.
• If the capacity of SD card is not enough to store the local user information, an error message
is displayed.
• Carefully handle the SD card, which contains user information. Do not take it back to your
location.
Upload
1. Turn off the main power switch.
2. Remove the controller cover ( x 1).
3. Install the SD card, which has already been uploaded, into the SD card slot 2.
4. Turn on the main power switch.
5. Enter the SP mode.
6. Do SP5-846-052 (Restore All Addr Book).
7. Exit the SP mode, and then turn off the main power switch.
8. Remove the SD card form the SD card slot 2.
9. Install the controller cover.
5. System Maintenance
304
To Next Page
Loading...
