• Make a temporary test chart as shown above using A3/DLT paper.
1. Place the temporary test chart on the ADF and make a copy from one of the feed stations.
2. Check the registration, and adjust using the following SP modes if necessary.
SP mode
Side-to Side: Front SP6-006-001
Side-to Side: Rear SP6-006-002
Leading Edge SP6-006-003
Buckle: Duplex front SP6-006-005
Buckle: Duplex rear SP6-006-006
Rear Edge Erase SP6-006-007
Sub Scan Magnification
• Make a temporary test chart as shown above using A3/DLT paper.
1. Place the temporary test chart on the ADF and make a copy from one of the feed stations.
2. Check the magnification, and adjust using the following SP modes if necessary. The specification is
±1%.
SP mode
Sub scan magnification SP6-017-001
Touch Screen Calibration
After clearing the memory, or if the touch panel detection function is not working correctly, follow this
procedure to calibrate the touch screen.
• Do not attempt to use items [2] to [9] on the Self-Diagnostic Menu. These items are for design use
only.
1. Press , input 1993 at the ten-key pad, and then press 5 times to open the Self-Diagnostics
menu.
4. Replacement and Adjustment
278
To Next Page
Loading...
