Ricoh OR-C1 - Tray Heater (Optional LCT)

7. Connect the harness [A] to the connector [B] of the tray heater.
8. Route the harness [A] and clamp it as shown ( x 3).
9. Connect the harness [A] to the connector [C] of the main frame through the hole [D].
10. Reassemble the main machine and optional paper feed unit.
Tray Heater (Optional LCT)
1. Pull out the LCT drawer.
• If the right tray comes out with the left tray, push the right tray into the LCT.
2. Installation
134
2