25*
Temp Inside the Machine
Displays the temperature measured inside the machine just after power-on (by the
thermistor on the BCU board) the last time that the fusing unit was less than 40°C just
after the machine was switched on.
The transfer current is corrected in accordance with this value.
[0 to 99 / 20 / 1 A /step]
2302* Transfer Current Switch Timing
1
Transfer Current Switch Timing Lead Edge
Adjusts the transfer current switch timing based on FGATE assert.
[–10 to 10 / 0 / 1 mm]
2
Transfer Current Switch Timing Trail Edge
Adjusts the transfer current switch timing based on FGATE negate.
[–10 to 10 / 0 / 1 mm]
2303* Transfer Roller Cleaning Bias
1
Positive
Adjusts the positive current of the paper transfer roller for cleaning the paper transfer
roller.
[0 to 20 / 10 / 1 A]
2
Negative
Adjusts the negative current of the paper transfer roller for cleaning the paper transfer
roller.
[0 to 20 / 4 / 1 A]
2801
Developer Initialization
Initializes the developer and resets the TD and ID sensor outputs to their defaults. Do
this SP after you fill the PCU with developer at machine installation and every time
developer is replaced.
System SP Tables-2
147
To Next Page
Loading...
