Ricoh OR-C1 User Manual

4 Book: Right
[0 to 3.0 / 0.0 / 0.1 mm / step]
5 ADF: Leading Edge
7 ADF: Right
8 ADF: Left
4013
Scanner Free Run
Performs a scanner free run with the exposure lamp on or off.
1 Lamp OFF
[0 to 1 / 0 / 1]
0=Off, 1=On
2 Lamp ON
4014
Scan
Performs a scanner free run with or without HP sensor check.
1 HP Detection Enable
• Touch [Execute] to start this feature.
• Press the (Clear/Stop) key to stop.
2 HP Detection Disable
4020
Dust Check
This function checks the narrow scanning glass of the ADF for dust that can cause black
lines in copies. If dust is detected a system banner message is displayed, but processing
does not stop.
1
Dust Detect:On/Off
Issues a warning if there is dust on the narrow scanning glass of the ADF when the
original size is detected before a job starts. This function can detect dust on the white
plate above the scanning glass, as well as dust on the glass. Sensitivity of the level of
detection is adjusted with SP4020 2.
[0 to 1 / 1 / 1]
0: Off. No dust warning.
1: On. Dust warning. This warning does not stop the job.
• Before switching this setting on, clean the ADF scanning glass and the white plate
above the scanning glass.
4. Appendix: Service Program Mode Tables
158
4

Ricoh OR-C1 Specifications

General

Brand	Ricoh
Model	OR-C1
Category	Printer
Language	English