6143
FIN (TIG) Output Check 1000-Sheet Finisher D589
Displays the signals received from sensors and switches of the booklet finisher.
Note: In the table below, "Display" is what you see on the screen, and "Component" is the
name used in the service manuals.
Display Component
1 Shift Motor Shift Tray Motor
2 Entrance Motor -
3 Staple Relay Motor Stapler Unit Motor
4 Knock Solenoid -
5 Junction Gate SOL 1 Proof Tray Gate Solenoid
6 Junction Gate SOL 2 Staple Tray Gate Solenoid
7 Folder Roller Rotation Motor Fold Roller Motor
8 Staple Motor Staple Fold Motor
10 Exit Guide Plate Motor -
11 Shift Relay Motor Upper Transport Motor
12 Tray Motor Shift Tray Motor
13 Stack Feed-out Motor Positioning Roller Solenoid
14 Stuck Relay1 Motor Upper Clamp Roller Motor
15 Stuck Relay1 Release Motor Upper Retraction Motor
16 Rear Edge Fence Drive Motor Bottom Fence Lift Motor
17 Folder Plate Motor -
18 Drive Roller Oscillating Motor Lower Retraction Motor
19 Staple Moving Motor Staple Unit Driver Motor
20 Jogger Motor Jogger Motor
21 Punch Registration Moving Motor Paper Position Sensor Slide Motor
22 Punch Motor -
4. Appendix: Service Program Mode Tables
262
To Next Page
Loading...
