Message Cause Solution and reference
"The program is recalled.
Cannot recall the folder
destination(s) with
protection code(s)."
A folder destination
specified with a
protection code is
included among the
programmed
destinations.
• You cannot recall a destination specified
with a protection code in a program.
Specify this destination individually.
• To program this destination, cancel the
protection code and then register the
destination to a program.
See "Using the Protection Function to
Prevent the Misuse of Addresses", User
Guide.
"The size of the scanned
data is too small. Check
the resolution and the
ratio and then press
[Start] again."
The data scanned by
specifying [Scan Ratio]
[Specify Size] is too
small.
• Increase [Send Settings] [Resolution].
• Specify a larger paper size in [Send
Settings] [Scan Ratio] [Specify
Size].
"Transmission has failed.
Insufficient memory in the
destination hard disk. To
check the current status,
press [Scan Files Status]."
The amount of available
hard disk space on the
destination computer,
SMTP server, or FTP
server is insufficient.
Check that the amount of free space is
sufficient.
"Transmission has failed.
To check the current
status, press [Scan Files
Status]."
A network error
occurred while
transferring the data due
to a busy network or
another reason.
If the same message is displayed after
scanning the original again, consult the
administrator.
"Exceeded max. number
of alphanumeric
characters for the path."
The maximum number of
specifiable
alphanumeric
characters in a path has
been exceeded.
Check the maximum number of characters
which can be entered, and then enter it again.
See "Sending a Stored File", User Guide.
"Exceeded the maximum
number of OCR jobs that
can be on standby for
storing, please wait. Try
again after storing of the
current job has
completed."
The maximum allowable
number of jobs on
standby was exceeded
because large quantities
of documents were
stored by the OCR
function.
Up to 100 jobs can be placed on standby by
the OCR function. Scan the next document
after the current jobs have finished being
stored.
When a Message Appears While Using the Scanner Function
415
To Next Page
Loading...
