Z-fold support tray 2
• Finisher shift tray
1. If the finisher is installed with the cooling fan unit, press the [Suspend / Resume]
key near the paper outlet port.
page 38 "Removing Prints from Finisher SR5090/Booklet Finisher SR5100 during
Printing".
If the finisher is not installed with the cooling fan unit, proceed to Step 2.
2. Remove the stack of paper from the finisher shift tray.
3. Attach the Z-fold support tray 3.
The back of the Z-fold support tray 3 is embossed with "3".
Z-fold support tray 3
Attach the Z-fold support tray 3 by inserting the two protrusions on its underside into the
holes on the finisher shift tray.
If the finisher is installed with the cooling fan unit, proceed to Step 4.
4. Press the [Suspend / Resume] key.
Finisher SR5110/Booklet Finisher SR5120
• Finisher shift tray 1 or 2
Special Notes When Using External Options
41
To Next Page
Loading...
