Attach the Z-fold support tray by inserting the two protrusions on its underside into the holes
on the finisher shift tray 1 or 2.
If you set [Finisher Output Tray Setting] to [Auto Change] and [Do not Stack Jobs], and
change where to deliver the paper when the Z-fold support tray is attached, multiple jobs may
be delivered to and stacked on the same tray.
Folding unit
1. Lift up and slide the Z-fold support tray for folding unit to the right, and then set it in
place.
When you have finished using the Z-fold support tray for folding unit, lift it up and slide the
tray to the left, and then lower it.
1. Getting Started
42
To Next Page
Loading...
