The selected functions are subject to User Code authentication. User Code authentication is not
applied to the functions not selected.
For details about limiting available functions for individuals or groups, see page 69 "Limiting
Available Functions".
To enable printer job authentication, set [Restrict Other Functions] to an option other than [PC
Control].
5. If necessary, specify the level for printer job authentication.
[Printer Job Authentication] Select the printer job authentication level [OK]
If you select [Simple (Limitation)], specify the range in which [Simple (Limitation)] is applied to
“Printer Job Authentication". You can specify the IPv4 address range to which this setting is applied,
and whether or not to apply the setting to the parallel and USB interfaces.
[Simple (Limitation)] [Change Limitation Range] Specify the range in which [Simple
(Limitation)] is applied to "Printer Job Authentication" [OK] [Exit] [OK]
For a description of the printer job authentication levels, see page 57 "Printer Job
Authentication".
6. Log out.
• This can also be specified via Web Image Monitor. For details, see the procedure for SP 4510DN.
User Code Authentication
35