To use the PostScript 3 Printer Driver
Follow the procedure below to set up the PostScript 3 printer driver:
1.
On the [Start] menu, select [Printers and Faxes].
2. Right-click the printer's icon, and then click [Properties].
3. Click the [Device Settings] tab.
4. Select [No] on the [Send CTRL-D Before Each Job:] and [Send CTRL-D After Each Job:], and
then click [Apply].
5. Click [OK].
Printing after Resetting the Printer
After the printer setting is reset, it will take 30–40 seconds to resume the connection. While the
printer is idle, jobs may be accepted (depending on NetWare specifications) but not performed.
To print after configuring the printer as the remote printer, check that the remote printer is disabled,
or wait for two minutes before printing.
3. Installing the Printer Driver for a Network Connection
22
To Next Page
Loading...
