• 2310 : Times New Roman Italic Medium
•
2311 : Times New Roman Italic Bold
• 5687 : Times Roman
• 5707 : Times Roman Bold
• 5815 : Times Roman Italic
• 5835 : Times Roman Bold Italic
• 20224 : Boldface
Characters Per Inch
Specifies the number of characters per inch (pitch) for the default font. Valid values are 5.0 to 30.0
in units of one tenth of an inch.
Default: [10.0]
Valid Printable Area Check
Specifies whether or not to report the Position check error (NACK 08C1..00) to the host, when
valid printable area is checked
Default: [On]
• On
The printer checks for pixels that fall outside the intersection of the logical and physical pages.
If there are pixels outside the area and error reporting has been set using the "IPDS Exception
Handling Control" command, the printer reports an error to the host.
• Off
The printer does not report pixels outside the valid printable area.
Edge to Edge
This function is disabled when using IPDS printing.
The printer maintains a border of 4.2 mm (0.165 inches) on all four edges of the paper.
• The "Edge to Edge" IPDS Menu item affects IPDS data only.
•
When using IPDS, the "Edge to Edge" setting on System menu will be invalid.
Font Substitution
Turns font substitution on or off.
Default: [Off]
• On
If a job requests a font that is not loaded on the printer, the printer uses a substitute font.
• Off
User Tools Settings
13
To Next Page
Loading...
