1. [Mac/ApliStat] tab
Indicates the status of the printer.
2.
Status icons
The icons that can be displayed are described below:
: The printer function is performing a job.
: An error has occurred on the printer.
: An error has occurred in the printer function being used, or the printer function cannot be used because an
error has occurred on the printer.
3.
Messages
Displays a message that indicates the status of the printer. This icon may also appear if the toner is running
low.
4. [Check]
If an error occurs, press [Check] to view details.
Pressing [Check] displays an error message or the printer screen. Check the error message displayed on the
printer screen and take the appropriate action. For details about error messages and their solutions, see
page 71 "When Messages Are Displayed".
The following table describes problems that cause the indicator to light:
Problem Cause Solution
Documents and reports do
not print out.
The paper output tray is
full.
Remove the prints from the tray.
Documents and reports do
not print out.
There is no paper left.
Load paper. For details about loading
paper, see page 37 "Loading Paper".
An error has occurred.
A function that has the
status "Error Occurred" in
the [Check Status] screen is
defective.
Press [Check], and then check the
displayed message and take appropriate
action. For details about error messages
and their solutions, see page 71 "When
Messages Are Displayed".
3. Troubleshooting
68
To Next Page
Loading...
Need help?
General
Weight and Dimensions
