Overstrike
The Overstrike control identifies text that is to be overstruck with a specified character.
Offset Range Meaning Error Code
0-1 X'2BD3' TEXT CONTROL Escape Sequence
2 X'05' LENGTH X'021E..
01'
3 OVERSTRIKE
X'72' Unchained
X'73' Chained
4 BYPASS IDENTIFIERS
Bits 0-3 Reserved
Bit 4: 0 Overstrike white space from RMI
Bit 4: 1 Bypass white space from RMI
Bit 5: 0 Overstrike white space from AMI
Bit 5: 1 Bypass white space from AMI
Bit 6: 0 Overstrike white space from Space or Variable Space
Character
Bit 6: 1 Bypass white space from Space or Variable Space Character
Bit 7: 0 BYPASS Treat Bits 0-6 according to their set values
Bit 7: 1 NO BYPASS Treat Bits 0-6 as if their values are set to zero
5 IGNORED
6 X'00' -
X'FF'
OVERSTRIKE CHARACTER
Relative Move Baseline
Relative Move Baseline Control Sequence moves a baseline coordinate relative to the current baseline
coordinate position.
Presentation Text Commands
113
To Next Page
Loading...
