Rigol MSO8000-BND - Figure 8.10 Delay Trigger

To Next Page

To Previous Page

Source A

Source B

Edge A

Edge B

Figure 8.10 Delay Trigger

Trigger Type:

Press Type, and then rotate the multifunction knob to select "Delay". Press down

the knob to select the trigger type. Then, the current trigger setting information is

displayed at the upper-right corner of the screen, as shown in the figure below. You

can also press

Type continuously or enable the touch screen to select it.

Source A:

Press SourceA to select CH1-CH4 or D0-D15 as the trigger source of Source A. For

details, refer to descriptions in "

Trigger Source

". The current trigger source is

displayed at the upper-right corner of the screen.

NOTE

Only when we select the channel (that has been input with signals) as the trigger source, can

we obtain a stable trigger.

Edge A:

Press EdgeA continuously to select the trigger edge type of Source A in Delay trigger.

It can be set to "Rising"

or "Falling" .

Source B:

Press SourceB to select CH1-CH4 or D0-D15 as the trigger source of Source B. For