Rigol MSO8000-BND - Parameter Setting Method

• Select "Trigger zone A":
- Draw the region for Trigger zone A;
- Open Trigger zone A:
- Open the "Zone Trigger" menu.
• Select "Trigger zone B":
- Draw the region for Trigger zone B;
- Open Trigger zone B:
- Open the "Zone Trigger" menu.
• Select "Histogram":
- Draw the region for the histogram;
- Open the "Histogram" menu.
• Horizontal zoom in: expands the waveforms in the horizontal direction.
Horizontal zoom out: compresses the waveforms in the horizontal direction.
• Vertical zoom in: expands the waveforms in the vertical direction. Vertical zoom
out: compresses the waveforms in the vertical direction.
• Waveform zoom in: expands the waveforms both in the horizontal and vertical
direction. Waveform zoom out: compresses the waveforms both in the
horizontal and vertical direction.
TIP
Tap the "Draw rect" icon to switch between the rectangle drawing and waveform operation
modes.
Tap the "Draw rect" icon, if is displayed, it indicates that the rectangle drawing mode is
enabled. Tap the "Draw rect" icon, if
is displayed, it indicates that the waveform operation
mode is enabled. By default, the waveform operation mode is enabled.
4.9 Parameter Setting Method
You can use the knob or enable the touch screen to set the parameters of MSO8000
series. The common parameter setting methods are as follows:
Method 1:
Quick Start
40
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.