The available choices include "Packets", "Details", and "Payload". You can
also tap "Packets", "Details", or "Payload" at the top of the event table to
select it.
If you select "Packets", the decoded data (MISO and/or MOSI), time, and
error information (MISO and/or MOSI) are displayed in the event table. If
you select "Details", the detailed data in the specified row will be displayed
in the event table. If "…" appears in the row of data, it indicates that the
decoded data are not fully displayed. At this time, you can view the details in
the "Packets" view. If you select "Payload", all data in the specified column
will be displayed in the event table. If "…" appears in the specified column of
data, it indicates that the decoded data are not fully displayed. At this time,
you can view the details in the "Packets" view.
- Export: If you select "Packets", you can export time and the corresponding
decoded data. Press
Export, then the save setting interface is displayed. You
can export the data table of the packet to the internal memory or the
external USB storage device (when detected) in CSV format. For detailed
saving operation, refer to descriptions in "
Store and Load
".
- Jump to: Set the operating status of the oscilloscope to "STOP". Then, select
the data of the specified time from the event table. Press Jump to and the
specified data waveforms are displayed in the center of the screen.
- Decode: The setting of this menu enables you to quickly view the
corresponding event tables of four decode modules (Decode1, Decode2,
Decode3, and Decode4). Press Decode, then use the multifunction knob
to select a decode module, then press down the knob to select it. You can
also press Decode continuously or enable the touch screen to select it.
15.5 LIN Decoding (Option)
The oscilloscope samples the LIN signal, and judges each data point to be logic "1" or
logic "0" according to the preset threshold level. The LIN decoding is required to
specify the LIN signal protocol version.
In the decode setting menu, press Decode1 > Bus Type, then rotate the
multifunction knob
to select "LIN". Press down the knob to select it. You can also
press Bus Type continuously or enable the touch screen to select it.
Protocol Decoding
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
253
To Next Page
Loading...
