- Adjust the vertical position of the bus
Press Position, and then rotate the multifunction knob to adjust the vertical
display position of the bus. You can also rotate Wave Vertical POSITIONto
adjust the vertical display position of the bus.
- Set the label display
Press
Label to enable or disable the label display of the I2C decoding bus.
When enabled, the bus label "I2C" will be displayed at the upper-left side of the
bus (when the bus display is enabled).
- Set parameters for the event table
Press Event Table to enter the event table setting menu. The event table
displays the decoded data and the corresponding decoding information in time
order in the form of a table. It can be used to observe relatively longer decoded
data. The decoding information includes the decoded data, the corresponding
line number, time, R/W bit, address information, and acknowledgement
information.
- Open or close the event table: Press
Event Table continuously to enable or
disable the display of the event table. When enabled, the following event
table as shown in
Figure 15.6
is displayed. You can also enable the touch
screen to tap the icon at the right-upper corner of the event table to close
it.
I2C Bus
Event Table
Line Number
Time
Acknowledgement
Decode Data R/W Bit Address
Figure 15.6 I2C Decoding Event Table
NOTE
Protocol Decoding
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
245
To Next Page
Loading...
