- Press Bit X to set the data bit that needs to be operated. For setting
methods, refer to descriptions in "
I2C Trigger (Option)
".
• Overload: triggers on the overload frames.
• Frame ID: triggers on the data frames with the specified ID. Set the following
parameters:
- Press Extend ID to enable or disable the extended ID.
- Press Bit X to set the data bit that needs to be operated. For setting
methods, refer to descriptions in "
I2C Trigger (Option)
".
• Frame Data: triggers on the data frames with the specified Data. Set the
following parameters:
- Press Bit X to set the data bit that needs to be operated. For setting
methods, refer to descriptions in "
I2C Trigger (Option)
".
- Press Bytes, then rotate the multifunction knob or use the numeric
keypad to set the length of the data. Its range is from 1 to 8.
• Data & ID: triggers on the data frames with the specified ID and data. Set the
following parameters:
- Press Define to select "Data" or "ID".
- When you select "Data", set Bit X and Bytes. For detailed settings, refer to
parameter settings for "Frame Data".
- When you select "ID", set Extended ID and Bit X. For detailed settings, refer
to parameter settings for "Frame ID".
• Frame Error: triggers on the error frame.
• Bit Fill: triggers on the error frame with the bit fill.
• Answer Error: triggers on the answer error frame.
• Check Error: triggers on the check error frame.
• Format Error: triggers on the format error frame.
• Random Error: triggers on the random error frame, such as the format error
frame, answer error frame, etc.
To Trigger the Oscilloscope
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
119
To Next Page
Loading...
