1 n2
Rising Edge Count = n
Threshold
Upper Limit
Threshold
Lower Limit
4. Falling Edge Count: The number of falling edges that fall from above the
threshold upper limit to below the threshold lower limit.
1 n2
Falling Edge Count = n
Threshold
Upper Limit
Threshold
Lower Limit
NOTE
• The above measurement items are only available for the analog channels.
• The default values for threshold upper limit and threshold low limit are 90% and 10%,
respectively. You can press > Setting to enter the sub-menu to set the parameters.
Delay and Phase Parameters
Source A
Source B
Period
Delay
Operations and Measurements
176
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
To Next Page
Loading...
