Press Version, and rotate the multifunction knob to select a protocol version
that matches the LIN bus signal. Then, press down the knob to select it. You can
also press Version continuously or enable the touch screen to select it. The
available versions include 1.X, 2.X, and Both.
5. Set Display-related Parameters
Press Display to enter the display setting menu.
- Set the display format
Press Format, rotate the multifunction knob to select the display format of
the bus data. Then, press down the knob to select it. You can also press Format
continuously or enable the touch screen to select it. The available formats
include Hex, Dec, Bin, and ASCII.
- Adjust the vertical position of the bus
Press
Position, and then rotate the multifunction knob to adjust the vertical
display position of the bus. You can also rotate Wave Vertical POSITION to
adjust the vertical display position of the bus.
- Set the label display
Press
Label to enable or disable the label display of the LIN decoding bus.
When enabled, the bus label "LIN" will be displayed at the upper-left side of the
bus (when the bus display is enabled).
- Set parameters for the event table
Press
Event Table to enter the event table setting menu. The event table
displays the decoded data and the corresponding decoding information in time
order in the form of a table. It can be used to observe relatively longer decoded
data. The decoding information includes the decoded data, the corresponding
line number, time, frame ID, cyclic redundancy check (CRC), and error
information.
- Open or close the event table: Press
Event Table continuously to enable or
disable the display of the event table. When enabled, the following event
table as shown in
Figure 15.9
is displayed. You can also enable the touch
screen to tap the icon at the right-upper corner of the event table to close
it.
Protocol Decoding
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
255
To Next Page
Loading...
