Press Operation and then rotate the multifunction knob to select "Save
Wave". Press down the knob to select it. You can also press Operation
continuously or enable the touch screen to select the type.
- Data source
Press Data Source continuously to select "Memory" or "Screen" as the source
of the saved waveform.
- Format
Press Format and then rotate the multifunction knob to select the waveform
format. Press down the knob to select it. You can also press
Format
continuously or enable the touch screen to select it. When the data source is
"Memory", the available formats are "*.bin" and "*.csv". When the data source is
"Memory", the available formats are "*.bin", "*.csv", and "*wfm".
- Storage channel
If the data source is "Memory", you need to set the storage channel. Press
Channel, and rotate the multifunction knob to select the storage channel.
You can also press
Channel continuously or enable the touch screen to select
the channel. The available storage channels include CH1-CH4.
3. Setup Saving
When the Quick shortcut key is set to "Save Setup", press on the front panel to
save the setup of the oscilloscope.
Press
Operation and then rotate the multifunction knob to select "Save Setup".
Press down the knob
to select it. You can also press Operation continuously or
enable the touch screen to select the type. You do not need to set relevant
parameters.
4. All Measurement
When the Quick shortcut key is set to "All Measure", press
on the front panel
to measure all the parameters of the current measurement source.
- Operation type
Press
Operation and then rotate the multifunction knob to select "All
Measure". Press down the knob to select it. You can also press Operation
continuously or enable the touch screen to select the type.
System Utility Function Setting
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
371
To Next Page
Loading...
