Roche Diagnostics
C-4 Operator’s Manual · Version 1.0
5 Daily operation URISYS 2400
System start
System start
a To start the URISYS 2400 analyzer
1 Turn the power switch to the ON (|) position. The [Please Wait] screen
appears. Loading and initializing of the software takes approximately 5
minutes. After the first loading stage, the progress is indicated on-screen.
2 Check and remedy any alarm messages. Clear the alarm messages.
3 Press <Home> on the [Copyright] screen. The [Routine Monitor] screen
is displayed.
4 Wait until the analyzer is in Stand-By status before continuing.
The power switch is located on the right side of the analyzer. The OFF position is
represented by
Ο.
“Instrument alarms (messages)” on page E-12
Figure C-1 Routine Monitor screen
To Next Page
Loading...
