Roche Diagnostics
C-28 Operator’s Manual · Version 1.0
5 Daily operation URISYS 2400
Analysis and documentation of results
Control sample data
The analyzer has a memory capacity of 100 samples for each of the specified
control rack positions. The results of all test parameters for a selected
sequence number are displayed on the screen.
Display control sample
data
a To display control sample data
The operator can access result data in the same way for all control samples.
1 Press <Menu> on the [Routine Monitor] screen. The [Menu] screen is
displayed.
2 Press <Data Monitor>. The [Data Monitor] screen is displayed.
3 Press <Control Data Monitor>. The [Control Data Monitor] screen is
displayed. The concentration results of the most recently tested control
sample are displayed.
4 Press <Prev> to display the results of previously measured control
samples.
5 Press <Level> to display the results of another level.
If no results are available for a sample, a message, for example “Sample short” is
displayed on the screen and printed on the printout.
Figure C-8 Control Data Monitor screen (concentration results)
To Next Page
Loading...
