Roche Diagnostics
Operator’s Manual · Version 1.0 C-13
URISYS 2400 5 Daily operation
Process additional samples
Process additional samples
The operator can feed additional samples when the analyzer is in Operation,
Sampling Stop, or Stand-By status. In Operation status, sampling proceeds
automatically; in Sampling Stop and Stand-By status, the operator must press
<Start> after loading the racks on the rack input line.
a To process additional samples
Operation status
1 Place the racks on the rack input line, either directly or using a rack tray.
2 When the rack end of the previous rack is detected, the rack pushers
automatically return to the front of the rack input line to search for
additional racks, and move them to the cross-feed line for sampling.
Sampling Stop status
1 Place the racks on the rack input line, either directly or using a rack tray.
2 Press <Start> on the [Routine Monitor] screen. The rack pushers
automatically move the racks to the cross-feed line for sampling.
Stand-By status
1 Place the racks on the rack input line, either directly or using a rack tray.
2 Press <Start> on the [Routine Monitor] screen. The analyzer performs a
reset; then the rack pushers automatically move the racks to the cross-feed
line for sampling.
To Next Page
Loading...
