Roche Diagnostics
Operator’s Manual · Version 1.0 C-33
URISYS 2400 5 Daily operation
Analysis and documentation of results
7 Press <Write> to write data to a diskette, or press <Read> to read data
from a diskette.
The option to read from a diskette is only available in binary format.
To write/read control sample data to/from a diskette, the analyzer must be in
Stand-By status.
Delete control sample
data
Sample data can be cleared from the memory either completely or selectively,
within a range of sequence numbers.
a To delete control sample data
1 Press <Level> on the [Control Data Monitor] screen to select the level of
controls.
2 Press <Media>. The [Control Data Monitor Media] screen is displayed.
3 Enter the range of sequence numbers to be deleted using numbers between
1 and 100. Enter 0 to delete all sample data.
4 Press <Delete>. The [Confirmation] window appears.
5 Press <OK>.
When reading control sample data from a diskette, all data of the selected level are
read. Currently stored data with identical sequence numbers are overwritten.
Selection of concentration or reflectance data is not necessary, because both data
are written or read simultaneously.
Control sample data are deleted only for the level selected in the [Control Data
Monitor] screen.
To delete control sample data, the analyzer must be in Stand-By status
To Next Page
Loading...
