Roche Diagnostics
Operator’s Manual · Version 1.0 C-5
URISYS 2400 5 Daily operation
System start
Start conditions before sampling
After powering on the analyzer, the operating conditions must be specified
and checked. These include the following:
o Specify the sample details.
o Specify the operator ID.
o Activate or deactivate the host connection as required.
o Select the print mode.
a To confirm the start conditions
1 Press <Start Condition> on the [Routine Monitor] screen. The [Start
Condition] screen is displayed.
2 Confirm that the details on the [Start Condition] screen are correct.
For input of numbers or change of the host and printer settings, the analyzer must
be in Stand-By.
Figure C-2 Start Condition screen
To Next Page
Loading...
