Roche Diagnostics
B-4 Operator’s Manual · Version 1.0
2 Hardware URISYS 2400
Hardware description
Standard accessories
The standard accessories that accompany the URISYS 2400 analyzer are:
o Water supply tank with a liquid level detector
o Water supply tube with filter
o Two rack trays
o Liquid waste tube 5 m (16.4 ft) length
o Strip waste container
o Standard maintenance kit (O-rings, seals)
o Fuses
o Power cord
o Three software installation diskettes
o Operator’s Manual (English version)
Water supply tank with liquid
level detector
The water supply tank that supplies deionized water to the analyzer is located
externally. It has a maximum capacity of 5 L (5.3 qts). This volume is
sufficient to process approximately 1000 samples.
Rack trays Two identical trays are supplied with the analyzer. Each tray holds up to 15
racks at one time. One tray is used to load the racks onto the rack input line.
The second tray is used as a stationary rack output tray during sample
processing and serves to remove racks from the rack output line.
Strip waste container Used test strips are deposited in a strip waste container that has a minimum
capacity of 420 test strips. (The capacity is calculated on the basis of the
contents of one URISYS 2400 cassette plus a safety margin.)
The strip waste container is located on the right side of the analyzer, behind
the door panel. The container is designed to minimize the contact an operator
has with potentially infectious and toxic materials.
When the strip waste container is full, a message is displayed on the touch
screen.
To Next Page
Loading...
