Roche Diagnostics
B-16 Operator’s Manual · Version 1.0
3 Software URISYS 2400
Installation
Setting the parameters
A number of parameters can be set individually according to laboratory
requirements if they deviate from the default factory settings.
The settings are automatically stored so that the data or analytical parameters
do not need to be re-specified each time, except when required. They can be
printed or saved to a diskette for documentation.
The setting of parameters is only possible when the analyzer is in Stand-By
status. For starting the analyzer, see:
If any mistakes related to the consistency of values occurred during setting of
parameters, the corresponding error alarm message does not appear until <Start>
is pressed for starting analysis. Check the alarm and correct the settings.
“System start” on page C-4
Figure B-8 System hierarchy chart of the progression through the different
screens of the Parameters menu
Parameters
Test Parameters System Parameters Parameter Media
Sieve & Abnormal
Print Order
Controls
Range Table
Units
Sample Barcode
Printer
COMM.Parameter
Date / Time
Password
Regist. Wash Rack
Load Parameters
Save Parameters
Print Parameters
To Next Page
Loading...
